Beam Clamps

RBC Beam Clamp

  • Versatile jaws designed to mount on a wide range of tapered or flat beams.
  • Built-in suspension bar allows for low headroom.
  • Easily installed and adjusted by hand.
  • Provides temporary or permanent mounting point for hook mounted hoists or lever pullers.
  • Designed to minimize stress applied to beam.

 

Specification

The scissor design adjustable beam clamp, allows hook mounting of manual or powered hoist, of the correct capacity

Chart

Model Max Beam width Weight 
  in mm lbs kg
BC-1

9.05

230

4

1.8

BC-2

9.05

230

5

2.3

BC-3

12.6

320

9

4.1

BC-5

12.6

320

11

5

BC-10

12.6

320

34

15.5

Installation

Position the beam clamp directly over work area. Fit jaws over the edge of the lower beam flange and tighten hand screws to secure the beam clamps. Rotate hand screw clockwise to close the jaws and clamp beam

Warnings

Do not use this beam clamp or attached equipment for lifting, supporting or transporting people or lifting or supporting loads over people

The supporting structures and load-attached devices used in conjunction with these beam clamps must provide a safty factor of at least five times the rated capacity of the beam clamp for powered hoist and four times for manual hoist.  This is a customer’s responsibilities. If in doubt, consult a registered structural engineer.