Eye Nuts Galvanized

Working load ratings are for in-line with respect to center line of shank.

  • For angular lifts, the shoulder type eye bolt should be used.
  • Angular lifts should not be applied to eyebolts taht are turned into a tapped hole.

Working Load Limit shown is for In-Line pull. Ultimate Load is 5 times the Working Load Limit. Rating based on standard tap size.

Size Standard Tap Size Dimension A(in) Dimension C(in) Dimension D(in) Dimension E(in) Dimension F(in) Dimension J(in) Dimension K(in) Dimension N(in) Dimension S(in) Dimension T(in) Dimension W(in) Working Load Limit (lbs) Weight (lbs)
1 1/4 1.25 0.75 1.00 0.75 0.50 0.69 0.63 0.46 0.25 1.72 0.31 520 0.09
2 3/8 1.62 1.00 1.20 0.83 0.56 0.81 0.89 0.58 0.31 2.09 0.41 1250 0.17
3A 1/2 2.00 1.25 1.44 1.08 0.81 1.00 1.09 0.73 0.38 2.55 0.50 2250 0.28
4 5/8 2.50 1.50 1.92 1.35 1.00 1.31 1.31 0.83 0.50 3.25 0.69 3600 0.60
5 3/4 3.00 1.75 2.28 1.59 1.12 1.50 1.57 1.05 0.63 3.96 0.84 5200 1.00
6 7/8 3.50 2.00 2.50 1.96 1.38 1.88 1.77 1.14 0.75 4.40 1.00 7200 1.65
7 1 4.00 2.25 2.92 2.21 1.56 2.13 2.02 1.30 0.88 5.10 1.19 10000 2.69
8 1 1/4 4.50 2.50 3.35 2.46 1.88 2.38 2.27 1.52 1.00 5.87 1.38 15500 3.87